washington dc drywall repair

It's inevitable that at some point, we shall all have a hole somewhere inside our home that we need to patch up. The bad news itself is the straightforward inconvenience and blemished wall if it's in an evident area. The good news is, that is quite simple to fix. The better still news is, it's easy enough to repair and make seem like there was never a hole in the drywall in the first place!

The precise drywall patching I recently did was to hide the hole in the drywall that must be cut to lower the piping that visited your kitchen sink. My spouse finally got the sink that she wanted. It had been nice in deep...heck, the ones that know me dc drywall installation how short I am...I could just about operate straight in the sink and you couldn't even see my head!! Okay, so that was a bit of stretch, but the idea is that it's a very deep sink. In fact, the sink was so deep, that after the disposal was added, the piping that connected to it had been now too high. While there is no [cheap] technology that defies gravity, the only option was to cut to the wall and lower the pipe.

I will cover both installing of the sink and the specific piping modification in separate posts. For now, we're just concentrating on fixing the drywall nightmare that people created to complete these projects.

Materials Needed:

Drywall Tape

Joint Compound

Wood Screws (#6 or #8, approximately 1" long)(Note: Can use drywall screws, also)

Orange Peel Texture (in can)

Drywall (size will depend on hole)

Some Type of Scrap Wood (I just cut some plywood)

Tools Needed:

Drywall Saw

Drill

Putty Knife

Sander

Next, you intend to cut you an item of wood that is about as wide (need a little room on the sides to place your hand to hold set up while screwing) and is longer by approximately 2 inches at the top and bottom. Just imagine a rectangle drywall contractors dc vertically over a square. Once that is cut, invest the hole and put a wood or drywall screw above the hole such that it catches the wood in the best or left corner. Do the exact same for the alternative corner and for both corners in the bottom of the hole. Now, you can place the bit of drywall that you cut (or saved) on the wood that's now fastened to the wall. Just set set up and put four screws in the piece such that it fastens to the wood also