linh xenang

I. Gas precautions when maintaining forklifts

Read more: https://xenangthienson.com/

The forklift manufacturing industry is located in the largest and most promising market in the world, with certain growth potential and a variety of industries such as forklift maintenance become a new industry. indispensable. Then repair and maintenance can be divided into main forklift maintenance and secondary forklift maintenance.

Then, when under the regular maintenance project, you can add the following level of maintenance work.

Read more: https://xenangthienson.com/xe-nang-dau/

- Check if the thermostat is working properly.

- Check if the transfer job of the transmission is normal.

- Check the tightness of the fan belt.

- Check if the diesel inlet filter is clogged and damaged, and clean or replace the filter.

- Check and adjust valve clearance.

- Check and adjust the distance between the brake pads of the hand and foot brake and brake drum.

- Check that the generator and starter motor are securely installed, and the end of the wire is clean and secure, check the carbon brush and commutator for wear.

- Change the oil in the oil pan, check if the vent of the box is intact, and clean the oil filter and diesel filter.

- Check for cylinder or vacuum pressure.

- Check if the wheel is securely installed, whether the tire pressure meets the requirements and remove debris embedded in the groove.

- Disassemble the parts due to maintenance work and perform a forklift road test after reassembling.

+ Braking performance under different levels must not be misleading or meandering. On a high slope, the handbrake may stop after being tightened.

Read more: https://xenangthienson.com/xe-nang-dien/

Listen for engine running under acceleration, deceleration, heavy load or no load, etc., with or without abnormal sounds.

+ After checking the mileage, check if the brake, transmission, front axle cover and gear pump are too hot.

+ Whether the lifting speed of the Hangcha forklift is normal and there is no vibration.

- Check if the multidirectional reversing valve, lifting cylinder, tilt cylinder, steering cylinder and gear pump are working properly.