PK Kumar

“I am good in hardware designing, which I like most and I am best at, and have more than 11 years of good experience”.

Summary:

1. Extensive and diverse experience in Hardware design and development

2. Printed Circuit Board design

3. C, C++, MicroPython, and assembly programming languages

4. DC and timing analysis

5. Power budget estimation

6. Good experience in Hardware and Software verification

7. Analog hardware design

8. DC power supply design

9. Good in High-speed digital design fundamentals

10. Good Knowledge of Digital circuits and microcontrollers

11. Experience in vendor and PCB designed coordination

12. Tools: Matlab, Visual DSP, Allegro, LTSpice, Orcad, Eagle, KiCAD, Zuken, Upverter, circuit studio, STM32CubeMx and more

13. Test Tools: Spectrum analyzer, Oscilloscope, Digital load, soldering, Signal generator, DC Poer analyser

I have good experience in microcontroller selection and hardware design from Renesas, Atmel, NXP, STM, TI and Analog devices. I have good experience in firmware development too.

I am an ACME (ARM Certified MCU Engineer)

If you have the project idea, I have the right tools, skills and approach for it. Nevertheless, will take up only those jobs which I can do, do well.

I have done my graduation in Electronics and communication with an 80% score.