Jamison Dawson

Bass drum creep does NOT refer to the scary guy with the bass drum, its the term used to describe the frustrating circumstance when your kick drum begins sliding further and further away from you with each and every stroke of your bass drum pedal.

Setting up your kit on a great thick rug or a carpet that the spikes at the end of your bass drum legs can sink their teeth into will typically aid maintain bass drum creep at bay. To research more, consider peeping at: girl drummer. (If your bass drum legs never have spikes, replace them with ones that do. To get another way of interpreting this, consider looking at: human resources manager. Any decent drum shop will carry replacement bass drum legs at a reasonable price.)

Make sure your carpet is big enough to match your entire kit, such as your throne. The weight of your body on the throne will assist hold the bass drum from sliding away with the whole carpet.

Adjust the bass drum legs so that the front of the drum is an inch or two off the ground and the drum is resting at a slight angle. This shifts much more of the drums weight onto the legs themselves and aids the spikes dig in far more effectively, which need to place an finish to most bass drum creep difficulties.

Occasionally, specifically for those of us kicking the drum quite difficult in loud situations, setting up on a carpet is just not adequate!

Here is an further tiny trick that will End bass drum creep troubles.

Take a 3 foot lengthy 2x4 piece of wood. Web Address contains more about the reason for it. I have some good fabric glued about it to make it appear pretty, supply some protection to the drums, and prevent splinters. Now mark your carpet where you want the front of your bass drum to sit. Drill 3 quarter inch diameter holes by way of the wood one hole in the middle and a single close to each and every end.

Using some good, big, 2 inch washers and 1/4 inch thick bolts actually bolt the wood to your carpet at the front edge of your bass drum. Make certain to put the flattest element of the bolt on the under side of the carpet so that your carpet still lays fairly flat. I also like to put a layer or two of gaffers tape more than the finish of the bolt so that it does not scratch up any good wooden floors